EINHELL TP-CL 18/3000 Li Instructions D'origine page 14

•
Threaded bushes, ¼" and ⅝" (Fig. 10 /
item 11): The threaded bushes can be used
to mount the lamp on a stand.
4.6 Tripod (Fig. 12-13)
Using the supplied tripod you can mount the lamp
at any position and any height.
•
To do so, open the fastening screw (f) and
then fold the three legs (g) apart (Fig. 12).
•
Then retighten the fastening screw (f).
•
With the help of the two telescopic poles (h)
you can now set any height.
•
To do so, turn the poles counter-clockwise
and then pull them out to the required height
(Fig. 12).
•
Finally refasten the telescopic poles (h) by
turning them clockwise.
•
With the help of the fastening screw (i) you
can fit and dismantle the ⅝ inch mount on the
tripod (Fig. 13).
5. Cleaning, maintenance and
ordering of spare parts
Danger!
Always remove the battery pack before starting
any cleaning work.
5.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
5.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
The light source of this lamp cannot be replaced.
When the light source reaches the end of
lifespan, the entire lamp must be replaced.
Anl_TP_CL_18_3000_Li_SPK13.indb 14 Anl_TP_CL_18_3000_Li_SPK13.indb 14
GB
5.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
6. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
7. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
- 14 -
31.10.2023 08:22:58 31.10.2023 08:22:58