Publicité
Les langues disponibles
Les langues disponibles
¡ If your appliance is not descaled in
good time, the display will show the
following message: "Descaling over-
due. Appliance is locked. Please
press menu for 3 sec.".
¡ If your appliance has been locked,
you can only operate it again once
the descaling process has been car-
ried out.
¡ If you accidentally interrupt the ser-
vice programme, you must reset it.
→ "Resetting service programmes",
Page 65
Tips
¡ If you use a water filter, this prolongs
the time interval until a service pro-
grammes needs to be performed.
¡ You can combine the cleaning and
descaling programmes using the
calc'nClean service programme.
→ "Using calc'nClean", Page 66
¡ Clean your appliance with a soft,
damp cloth immediately after a ser-
vice programme to remove any de-
scaling solution residues and pre-
vent corrosion.
Resetting service programmes
Perform the following steps if a service
programme is interrupted, e.g. due to a
power failure.
Rinse out the water tank.
1.
Fill the water tank with fresh, non-
2.
carbonated water up to the "max"
marking.
Press
.
3.
a The appliance will rinse itself for ap-
prox. 2 minutes.
Empty and clean the drip tray.
4.
Insert the drip tray and close the
5.
door.
Restart the service programme.
6.
Cleaning and servicing en
Using the milk system cleaning
programme
Rinse the milk system with water, if ne-
cessary. The rinsing process takes ap-
prox. 1 minute.
Press
.
1.
Use
and
2.
and care" and press
Use
and
3.
tem" and press
To start the programme, press
4.
a The display will guide you through
the programme.
Remove and empty the milk con-
5.
tainer.
Clean the milk container, milk tube
6.
and suction pipe.
Fit the components and insert the
7.
milk container.
Place an empty glass under the out-
8.
let system and press
The milk system will now clean itself
automatically.
a The program has ended and the ap-
pliance is ready for operation.
Tip: If you want to clean the milk sys-
tem particularly thoroughly, clean it reg-
ularly by hand.
→ "Cleaning the milk system", Page 62
Using the descaling programme
Run the descaling programme when
your appliance prompts you. The pro-
cess takes approx. 30 minutes.
Requirement: The brewing unit is
cleaned.
→ "Cleaning brewing unit", Page 64
Press
.
1.
Use
and
2.
and care" and press
Use
and
3.
and press
.
to select "Cleaning
.
to select "Milk sys-
.
.
to select "Cleaning
.
to select "Descale"
.
65
Publicité
