Publicité
Les langues disponibles
Les langues disponibles
11. Confirm Proper Operation
Fill the Whirlpool
NOTE: Please read these steps carefully before you operate your whirlpool.
- Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully counterclockwise.
- Fill the whirlpool to a water level at least 2" (5cm) above the top of the highest jet.
NOTE: The water temperature in the whirlpool should not exceed 104_F (40_C).
Operating Sequence
NOTE: A built in heater automatically maintains the water temperature when the whirlpool is running.
- Press the Jets" button to turn on the whirlpool at high speed.
- Adjust each jet for optimum air/water mixture. Turn the trim ring clockwise to reduce the air flow, and
counterclockwise to increase the air flow.
- Press the Jets" button again to run the whirlpool at low speed.
- Press the Jets" button a third time to turn off the whirlpool.
NOTE: A built in timer automatically stops the whirlpool after approximately 20 minutes of operation.
Kohler Co.
Press the "Jets"
button to turn on and
off the whirlpool
functions
Turn the jet trim
ring clockwise to
decrease the flow
9
Turn the jet trim ring
counterclockwise to
increase the flow
1011611-2-
B
Publicité
