Sharp LL-T15G1 Mode D'emploi page 19

Manual screen adjustment
Adjustments can be made using On Screen Display
(OSD) Menu provided.
1. Display an image that makes the entire screen
very bright. If using Windows, you can open and
use the Adjustment Pattern on the accompanying
Utility Disk. (p. 18)
2. Press the MENU button.
The ADJUSTMENT Menu will be displayed.
ADJ US TMENT
MANUAL
CL OCK
PHASE
H-POS
V-POS
1 0 2 4 X 7 6 8
V : 7 5 H z H : 6 0 . 0 k H z
At this point relevant menu options can be
adjusted.
Each time the MENU button is pressed the next
menu is selected. (ADJUSTMENT → GAIN
CONTROL → WHITE BALANCE → MODE
SELECT → OSD Menu disappears)
Notes:
- The OSD Menu automatically disappears
approximately 30 seconds after the last
command.
- This explanation is based on using the
Adjustment Pattern (for Windows) to make
adjustments.
All manuals and user guides at all-guides.com
Adjusting the screen display
AUTO
127
16
200
29
19
ADJUSTMENT Menu
ADJ US TMENT
MANUAL
CL OCK
PHASE
H-POS
V-POS
1 0 2 4 X 7 6 8
V : 7 5 H z H : 6 0 . 0 k H z
MANUAL: Individual menu options are manually
adjusted.
AUTO: Every menu option is automatically
adjusted.
Notes:
- Press the button to select [AUTO].
- To choose a menu option: SELECT button
- To go to the next menu:
CLOCK
The figure below demonstrates how to adjust so that
vertical flicker noise is not emitted. (
Vertical flicker noise
PHASE
The figure below demonstrates how to adjust so that
horizontal flicker noise is not emitted. (
Note:
- Adjustments to PHASE should be made only
after CLOCK has been correctly set.
Horizontal flicker noise
H-POS (horizontal positioning) and V-POS
(vertical positioning)
To center the screen image within the boundaries of
the screen, adjust the left-right (H-POS) values and
the up-down (V-POS) values. (
Adjustment
pattern
AUTO
127
16
200
29
MENU button
buttons)
buttons)
buttons)
Screen frame