System Safety - Electrolux HSG Panini Manuel D'utilisation

2-7 SYSTEM SAFETY

All the laws, regulations and directives in force in the place of
installation regarding the following must be observed:
- Electricity
- Refuse and waste disposal
2-8 HAZARDS IN THE WORKPLACE
2-8-1 Fires
Curtains, dishcloths, chopping boards or other wooden objects
must be kept away from burners and sources of heat; the same
applies for recipients containing alcohol, solvents or fl ammable
cleaning materials, etc.: the risk of fi re in the kitchen is very
high.
Never use water to extinguish the start of fi res of an electrical
nature: use suitable extinguishing materials or appropriate fi re-
extinguishers after turning the power off and unplugged!
2-8-2 Accidents
The risk of accidents to persons (burns, falls) is also very high:
immediately clean any drops of oil or grease ending up on the
fl oor.
Close carefully the lid with making sure that there is nothing that
could block or be pinned down.
Be careful with hot surface.
2-8-3 Electricity
Some instructions regarding the electrical systems and the
actions of persons:
- Electrical system: execution and maintenance must be carried
out by qualifi ed personnel, in compliance with current safety
standards. The main switch and the plug must be easily rea-
ched in case of need. Leads, plugs and sockets must always
be kept in perfect condition.
- Actions: unplug the appliance before cleaning or any other
operation on the appliance.
2-9 ELECTRICAL DATA / CONNECTION
Connection to the electrical power supply must be done according to proper professional practice by a qualifi ed and authorised
person (see current standards and legislation in the country of installation).
Do not use multiple plugs
The AC power supply to the appliance must comply with the following conditions;
- Maximum voltage variation: ±5%
- Maximum frequency variation: ±1% on a continuous basis, ± 2% over short periods
ATTENTION: the electrical installation must comply (for design, creation and maintenance) with the legal and standard
requirements in the country where used.
- Before connecting the appliance to the electrical power supply, check that the voltage of the electrical system is the same as
that marked on the rating plate and the label on the power cable.
- The appliance's electrical power supply must be protected against voltage surges (short-circuits and excess voltages) by
using fuses or thermal relays of the appropriate gauge relative to the place of installation and appliance specifi cations.
ATTENTION: Concerning protection against indirect contact (depending on the type of power supply provided and
connection of the exposed conductive parts to the equipotential protection circuit), refer to point 6.3.3 of EN 60204-1 (IEC
60204-1) with the use of protection devices for automatic shut-off of power in the event of an insulation fault with a TN or
TT system, or, for the IT system, with the use of a permanent insulation or differentials controller for automatic shut-off.
The requirements of IEC 60364-4-41, 413.1 must apply for this protection.
For example: in a TT system, a differential circuit breaker must be installed upline of the power supply, with a suitable
power cut-off (e.g.: 30 mA) on the earthing installation for the place where it is planned to install the appliance.
ATTENTION: Failure to comply with these instructions means the customer runs the risk of appliance failure and/or
accidents due to direct or indirect contacts.
Warning!
Never unplug the appliance by pulling the cord but only by the
plug!
If the cord is deteriorated, do not try to fi x it with insulating tape or
similar products, but have it replaced by qualifi ed personnel.
2-8-4 Work in safety
Not knowing or underestimating the risks due to incorrect or
improper use of the individual appliances can be a source of
danger. Good habits in daily use are important.
- Learn to correctly use the various appliances making up the
installation. At the end of work, always make sure the appliances
are off.
- Do not use fl ammable substances for cleaning and do not leave
containers with those substances near the appliances.
THE APPLIANCE IS INTENDED FOR PROFESSIONAL
USE AND MUST BE USED BY COMPETENT
PERSONNEL!
Warning picture present on the appliance
ATTENTION !!
5/11
CAUTION HOT SURFACES
CAUTION RISK ELECTRIC SHOCK
HSG GB 06 2009