Blending; Cleaning - SilverCrest SHMS 300 B1 Mode D'emploi

Blending

Warning:
Never use the blender w for hard foodstuffs such as:
coffee beans, ice cubes, sugar, cereals, chocolate,
raw/hard vegetables etc. They could cause serious
damage to the appliance.
Attention:
Under no circumstance should you use receptacles
made of glass or other very fragile/easily breakable
materials. These containers can be damaged and
then cause potentially serious injuries.
1. Open the fixture for the blender 3 and hold the
safety cover 3 firmly.
Note:
The blender w can only be utilised when the
whisks e or the kneading hooks r are not installed.
2. Insert the blender w until it engages and then
twist it firmly tight.
3. To avoid overflows, the container used for blen-
ding should only be filled to 2/3rds of its capa-
city. Select a sufficiently large container.
Tips:
• To ensure an effective blending of the ingredients,
the foodstuffs to be processed should cover at le-
ast the lower section of the blender w.
• First switch the hand mixer on when the blender w
has been inserted into the ingredients to be
blended.
4. Push the speed switch 1 into the position "Blen-
der" (s. section " Speed levels") and press the
turbo button 2 Keep the turbo button 2 pres-
sed down during the whole procedure. The ap-
pliance stops as soon as it is released.
Warning:
Do not operate the blender w for longer than 1
minute in one session. After one minute, allow the
appliance to rest until it has cooled itself down.
5. When you have finished working with the blen-
der w, place the speed switch 1 back into the
position "0" and remove the plug from the mains
power socket.
Attention:
Clean only the lower part of the blender w under
running water. Under no circumstances may water
permeate into the blender w. This could result in
damage to the appliance.
6. To clean the blender w twist and remove it from
the retaining mechanism 3.

Cleaning

Attention:
Always remove the power plug before cleaning the
appliance. There is a risk of receiving an electric
shock!
UNDER NO CIRCUMSTANCES may the
hand element 0 be submersed in water or ot-
her liquids! ! This would increase the risk of a
potentially fatal electric shock should liquids
come into contact with powered components.
• Clean the hand element 0 with the electric mo-
tor only with a damp cloth and, if necessary,
with a mild detergent.
• Clean the mixing stand 6 only with a moist
cloth and, if required, with a mild cleaning deter-
gent.
• The whisks e and the kneading hooks r can
be cleaned under running water or in warm
water with detergent. Dry everything well after
cleaning.
- 26 -