Ryobi ERGO-A2 Mode D'emploi page 16

Safety, performance, and dependability
have been given top priority in the design
of your screwdriver.
INTENDED USE
The product is intended to be used only
by adults who have read and understood
the instructions and
this manual, and can be considered
responsible for their actions.
The product is intended for fastening and
removing screws and bolts.
Do not use the product in any way other
than those stated for intended use.
NOTE: It is recommended to use pilot
holes prior to driving screws.
WARNING
Read all safety
instructions, illustrations
specifications provided with this
power tool. Failure to follow all
instructions listed below may result
in electric shock, fi re and/or serious
injury.
Save all warnings and instructions for
future reference.
SCREWDRIVER SAFETY
WARNINGS
■
Hold the power tool by insulated
gripping surfaces,
performing an operation where
the fastener may contact hidden
wiring. Fasteners contacting a "live"
wire may make exposed metal parts
of the power tool "live" and could give
the operator an electric shock.
■
Ambient temperature range for tool
during operation is between 0°C and
40°C.
■
Ambient temperature range for tool
storage is between 0°C and 40°C.
1
Original Instructions
CHARGER SAFETY WARNINGS
■
warnings in
■
■
■
warnings,
and
■
when
■
■
■
Before using battery charger, read all
instructions and cautionary markings
in this manual, on battery charger,
battery, and product using battery to
prevent misuse of the products and
possible injury or damage.
Do not use charger outdoors or
expose to wet or damp conditions.
Water entering charger will increase
the risk of electric shock.
Use of an attachment
recommended or sold by the battery
charger manufacturer may result in
a risk of fire, electric shock, or injury
to persons. Following this rule will
reduce the risk of electric shock, fire,
or serious personal injury.
Do not abuse cord or charger. Never
use the cord to carry the charger.
Do not pull the charger cord rather
than the plug when disconnecting
from receptacle. Damage to the cord
or charger could occur and create
an electric shock hazard. Replace
damaged cords immediately.
Make sure cord is located so that it
will not be stepped on, tripped over,
come in contact with sharp edges or
moving parts or otherwise subjected
to damage or stress. This will reduce
the risk of accidental falls, which
could cause injury, and damage to
the cord, which could result in electric
shock.
Keep cord and charger away from
heat to prevent damage to housing or
internal parts.
Do not operate charger with a
damaged cord or plug, which could
cause shorting and electric shock. If
damaged, have the charger replaced
by an authorised serviceman.
Do not operate charger if it has
received a sharp blow, been dropped,
or otherwise damaged in any way.
Take it to an authorised serviceman
not