Franke FME 407 XS Mode D'emploi Et Installation page 13

• Tighten the power supply cable and fix it to the
Bracket on the ceiling mounted Plate, using the
tongue already mounted and 2 screws.
• Slot the rubber cable raceway already
threaded onto the power cable into the
slot to prevent future damage.
• Connect the Hood to the
Mains Power Supply,
inserting a bipolar switch
with a contact aperture of
at least 3 mm.
• Remove the Grease filters
(see paragraph
"Maintenance") and make
sure that the Power cable
has been properly inserted
into the Suction fan
socket.
• Screw the Cover back onto the Plate using the
screws removed previously.
• Open the lighting unit by pulling on the notch provided.
• Remove the grease filter.
• Make sure that the Activated charcoal odour filter has been fitted.
EN
FIXING THE POWER SUPPLY CABLE
FITTING THE PLATE COVER
AIR OUTLET – RECIRCULATION VERSION
1 13