Pur Line RADOIL A Manuel De L'utilisateur page 21

heater will switch out automatically and the symbol
to the previous mode if the room temperature raise more than 2ºC in 5 minutes. However you can manually
restart the heater by pressing
Under standby mode, press and hold
flickers on the screen.
Press or button to change the symbol from
LOCK
The device will automatically lock if left unatended for 30 seconds.
To unlock the radiator at any time(a key icon will be visible in the middle left pane of the display) press
and at the same time.
TEMPERATURE CALIBRATION
Under standby mode, press and hold
First, the screen will come out F1, please note this is used for heater's internal sensor temperature adjustment,
please never adjust it.
Second, after F1 come out, press
"temperature calibration" from -5ºC to 5ºC.
SAFETY DEVICE FOR ANTI-OVERHEATING
The radiator is fitted with a safety device which switches off the heater in case of overheating. In case the
heater stops working, turn off the heater and carry out an inspection at the entrances and air vents to see if
they are clogged. Wait at least 5 minutes so that the protection system is reset before restarting the heater.
If the heater does not work or if the safety device off again, bring the device to the service center nearest
aftermarket for consideration or repaired.
. The symbol disappears of the screen.
button for 5 seconds, symbol
indicates "function not in operation".
button for 10 seconds:
button to change to F2, then press
flickers on your screen. The heater will come back
shows on the screen and symbol
to , indicates "function in operation".
19
or button to change