Publicité
Les langues disponibles
Les langues disponibles
Cleaning the side walls of the oven
The side walls in the cooking area can only
be covered with enamel or catalytic walls. It
varies by model. If there is a catalytic wall,
refer to the "Catalytic surfaces" section for
information.
If your product is a wire shelf model, re-
move the wire shelves before cleaning the
side walls. Then complete the cleaning as
described in the "General Cleaning Informa-
tion" section according to the side wall sur-
face type.
To remove the side wire shelves:
1. Remove the front of the wire shelf by
pulling it on the side wall in the opposite
direction.
2. Pull the wire shelf towards you to re-
move it completely.
3. To reattach the shelves, the procedures
applied when removing them must be
repeated from the end to the beginning,
respectively.
7.5 High temperature self-cleaning
The oven is equipped with a pyrolysis fea-
ture. The oven heats up to a temperature of
approximately 420-480 °C and burns until
the existing dirt turns to ash. A strong
smoke may be generated. Provide good
ventilation. High-temperature cleaning
should be performed after approximately
every 10 uses of the oven.
General warnings
Hot surfaces cause burns!
Do not touch the product during
self-cleaning and keep children
away from the product. Wait at
least 30 minutes before removing
the residue.
• Before using the pyrolysis function, re-
move all accessories, the telescopic
shelf and the side shelves (if any). If not
removed, the accessories and side wire
shelves will be damaged.
• If your product has a pyro proof access-
ory (resistant to high temperature self-
cleaning), you do not need to remove
these accessories from the oven.
Whether your accessories are pyro-proof
or not is specified in the accessories sec-
tion. If not specified, your accessories
are not resistant to high temperatures. It
must be removed from the oven before
cleaning to avoid damage.
• Do not clean the door seal. The glass
fiber seal is very delicate and easily dam-
aged. If the door seal is damaged, re-
place it with a new one from an author-
ized service.
To start the pyrolysis function:
1. Remove all accessories inside the oven.
In the models with wire shelves, remem-
ber to remove the wire shelf.
2. Before starting the cleaning, clean the
outer surfaces of the oven and the food
residues inside the oven with soapy
cloth.
3. Select the "pyrolysis" (Pyrolysis) func-
tion.
ð The "P2:00" flashes on the display.
If your appliance is equipped with
the Eco pyrolysis function, the
"Pro" message is displayed on the
display for 2 seconds first, and
then the P2:00 message starts to
flash.
EN / 32
EN
FR
Publicité
