Sentiotec KASKI 180 PANORAMA Instructions De Montage page 8

Assembly instructions
Mount the tensioning bands[24] (see page 19).
Before tensioning the metal bands, remove the screws from the staves.
Note that the tension rods[23,25,26,27] are positioned in the lower half
of the barrel sauna.
Tighten the metal bands so that there is no visible gap between the staves. This
must be checked regularly and retightened if necessary.
2.5. Mounting the door
Place the door frame[13,17] in the opening from the inside. Note that the door
opens outwards – the door can be attached on the left or on the right.
Fix the door in place from the outside using the cover strips[15].
The door handles are screwed from the inside.
2.6. Installing interior fittings
Fit the bench support slats[9] at a height of approx. 52 cm to the lower stave.
Position the benches[18] and screw them to the stave.
Mount the backrests[19] approx. 20 cm above the bench.
2.7. Installing accessories
Position the floor grid[11] so that it is level.
Assemble the protection grille[35,36,37,38].
Fit the ventilation panel[29] on the inside and the insect screen[28] on the outside.
For the lighting, first fit the metal clips on the wooden strip. Clamp the LED strip[22]
and drill a hole for the cable gland at the desired location (the power supply unit
may be placed outside the sauna).
Use the cable cover slats[21a,b] as required for the cable installation.
2.8. Covering the roof
Install the triangular strips[10] (drip edge) at a height of approx. 116 cm.
Start attaching the bitumen shingles[30] at the triangular strip, with the top of the
first shingle sheet facing down. Now lay the other shingle sheets overlapping
and evenly offset. You can make the top ridge row from sections. These are laid
overlapping in a scale-like manner. Pay attention to the prevailing wind direction.
The mounting strips on the inner walls can now be removed.
p. 8/8