Crivit SC-10987 Notice D'utilisation page 12

Preventing damage to the
product!
• Avoid water, oil, potholes and very rough
surfaces.
Assembly (Fig. B)
The product is delivered in several parts for
transport. Proceed as follows to get it ready for
scooting:
1. Take the product out of the packaging and
insert the handlebar (2) into the stunt scooter
tube (1) as shown in Figure B.
2. Using the hex key (4), tighten the three screws
(3a) that are located in the clip (3) of the han-
dlebar, one after the other from top to bottom.
Repeat this procedure at least 3 times.
Note: regularly tighten the retaining screws on
the clip, as described.
Use (Fig. C)
Riding, braking, parking
• Put one foot on the deck and supply momen-
tum by regularly pushing off from the ground
with the other foot.
• Step on the brake plate (1a) to brake.
• Park the product on a level surface only by
leaning it against a wall.
Maintenance
Replacing the wheels
Important!
Pay attention to the 'Technical data' section.
Wheels that have a different diameter may alter
the riding characteristics and could possibly en-
danger the user. Do not use wheels that cannot
be installed properly. Never use wheels that are
larger than the original wheels on the product.
Wheels wear out. This wear depends on many
factors, for example, the terrain, the size and
weight of the user, the weather conditions, the
material of the wheels and their hardness. It is
therefore necessary to replace them regularly.
12 GB/IE
Replacing the back wheel (Fig. D)
1. Unscrew the axle bolt (1b) with both hex keys
(4).
2. Pull out the axle bolt and remove the wheel.
3. Attach the new wheel (1d) as well as both
spacers (1c) with the axle bolt.
Replacing the front wheel (Fig. E)
1. Unscrew the axle bolt (1b) with both hex keys
(4).
2. Pull out the axle bolt and remove the wheel.
3. Attach the new wheel (1d) with the axle bolt.
After replacing a wheel
Do not use the wheel if it pulls sideways after
installing it!
After the first few minutes of riding, make sure
that all screws and bolts are still tight and that
nothing has detached or become loose.
Tension the wheel once more to make sure that
it is running quietly and that the bearings are not
making any noise.
Replacing the ball bearings (Fig. F)
1. Remove the wheel (1d) as described in the
section 'Replacing the wheels'.
2. Use a hex key (4) to lever out a bearing (1e).
3. Remove the inner ring of the ball bearing (1f)
from the wheel and turn the wheel over.
4. Lever out the other bearing with a hex key.
5. Press in a new bearing. Turn the wheel over,
insert the spacer and then push in a second
new bearing.
6. Secure the wheel again as described in the
section 'Replacing the wheels'.
Storage, cleaning
We recommend that you clean and dry the
product thoroughly after use.
Remove small stones or other objects that may
have got caught on the wheels. Dry wet or
damp ball bearings with a clean cloth. Grease
the bearings with a suitable bearing lubricant
from the outside to prevent external rust.
Always store the product in a dry place.