Publicité
Les langues disponibles
Les langues disponibles
O
PERATING THE UNIT
3. Rotational speed indicator:
The rotational speed indicator (E) is on the left next to the rotational speed regulator/
rotational direction regulator (D). This indicates the selected rotational speed by means of
5 LEDs. The device functions with maximum rotational speed when all LEDs light up.
E. Before the first use, make sure that you let the handpiece run for about 30 minutes at approx.
16.000 rpm (2 LED lights of the speed indicator (E) should flash). This is necessary to bed in the
carbon brushes of the motor.
F. Use of foot pedal (optional accessory):
Set the rotational speed regulator (D) on "zero" (middle position). Connect the foot pedal
(O) to the socket (H). The foot pedal LED (F) lights up yellow if the foot pedal is correctly
connected. The running direction and rotational speed are set by turning the rotational
speed regulator/rotational direction regulator (D). The device is now in standby mode.
Turn the device on by pressing the foot pedal. The abrasive wheel starts to rotate in the
direction and rotational speed you selected. You switch into the standby mode by pressing
the foot pedal again.
Attention:
Never connect the foot pedal (O) to the station or remove this from the station while an
abrasive wheel is turning in the hand piece. The device switches itself off in the event of
non-compliance (SAFETY STOP). The rotational speed regulator (D) must absolutely be set
at "zero" (middle position) to plug in or remove the foot pedal.
Note:
Only Promed foot pedals can be used.
Note:
A different running noise between clockwise and counter-clockwise rotation is normal and caused
by bedding in of the carbon brushes or by running in of bearings.
In case of malfunction:
• Check that the power supply is correct.
• Check whether the handpiece is connected correctly to the unit.
• Check whether the safety stop device has reacted by setting the device at zero (middle
position) with the rotational speed regulator/rotational direction regulator (D) in order to
start the device again.
• Check whether the foot pedal is properly connected with the device (foot pedal LED (F)
lights up yellow).
• Please contact your service point if the problems are not yet solved.
Kaitstud / Secured by https://mereneid.eu/
DE
EN
FR
IT
ES
NL
RU
PL
SE
FI
Publicité
