ProMed 1030 Instructions D'utilisation page 15

S
AFETY INSTRUCTIONS
• Never carry or pull the unit by the power cord. Use the plug to pull the power cord out of
the wall socket. Do not pull on the power cord itself.
• Do not pull the power cord over sharp edges, wedge it in between objects, hang it down
or position or hang it over hot objects (e.g., hot plates) or naked flames. Protect the power
cord from heat or oil.
• Only use extension cords when you have satisfied yourself beforehand that they are not
defect or damaged.
• If the power adapter or its cable are damaged, immediately have it replaced by an expert.
• Do not store the unit near a wash basin or bath tub as there is the danger that the unit may
fall or be pulled into the wash basin or the bath tub.
• Children must not clean or maintain the device without supervision.
• To avoid all risks of injury, blockage or damage to the unit, make sure that the unit does
not come into contact with clothing, cords, shoelaces, bristles, wires, threads, hairs etc.
when in operation.
Note:
The AC adapter may become slightly warm. This does not indicate a malfunction. The
device can be used easily.
I
NFORMATION ON THE UNIT
Before operating the unit for the first time, please check that all contents have been delivered and
that the line voltage is correct. The supplied power adapter (A) is an electronic power supply
unit intended for an operating voltage of 100 VAC to 240 VAC. Should you require a different
plug type for the operation of the device, you can purchase it from Promed. To change the
plug type, press the release (M) and pull the power plug (N) from the power supply unit (A).
Take the required power plug (N) and push it back into the power supply unit (A).
• The Promed 1030 device is outstandingly suitable for manicure with the abrasive wheels
provided for this purpose, but especially for use in nail technique (nail design).
• The Promed 1030 unit uses a high performance motor. The electronic speed control
is used to smoothly set the speed of the grinding head. The unit can rotate clockwise or
counterclockwise (reversible).
• The grinding head holder is able to fixate all commercial grinding heads with standardized
dental size shafts of (ø 2.332 to 2.350 mm / 0.091 - 0.093 inches). Please use only high-
quality grinding heads with a rounded shaft end and a maximal shaft length of 36 mm
(1.26 inches) to guarantee the longest life possible for the grinding head holder!
• If you want to remove the hand piece (J), just insert it in the hand piece holder (G)
provided for this purpose.
• Always make sure that the grinding head does not come in contact with other objects
when you lay the handpiece down. There is a risk of the shaft becoming compressed and
asymmetrical. Asymmetry in the grinding head causes damage to the handpiece!
• Grinding head bits are available at your local specialist retailer or Promed (www.promed.de).
• To ensure hygienic operation, the grinding heads must be disinfected after use.
• The handpiece may only be disinfected using disinfectant wipes.
/ S
COPE OF DELIVERY
Kaitstud / Secured by https://mereneid.eu/
/
ACCESSORIES
DE
EN
FR
IT
ES
NL
RU
PL
SE
FI