Linea 2000 DOMO B3975 Mode D'emploi page 53

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

B3975
HOW TO USE THE TIME DELAY FUNCTION
When you want to use the time delay function, you should program it before you press
the start button.
IMPORTANT: never use the time delay function with easily perishable ingredients.
Please carry out the fi rst 8 steps, as described in the chapter "Operating instructions".
Next, after having selected the program and the crust colour of your choice, you press
the arrow buttons in order to adjust (decrease or increase) the time set on the display.
Cf. chapter "display".
Example: the time is 9 am and you want your bread to be ready by 5 pm. Put all
ingredients in the bread pan. Place the bread pan in your bread maker. Close the
lid and select the program and the crust colour of your choice, using the respective
buttons. Keep pressing the button with the arrow pointing up until you see "8.00"
on the display. For, evidently, 8 hours will pass between the time you press the start
button and the time you want your bread to be ready (in this case 5 pm).
Press the start button. The colon on your display will start to fl ash and the bread maker
will start the countdown, until it is time for the bread maker to begin the kneading.
The bread maker will let the program run entirely, ensuring the bread will be ready at
the desired time.
HOW TO CLEAN YOUR BREAD MAKER
Before cleaning your bread maker, please ensure it is no longer activated, it has
suffi ciently cooled down and the plug has been disconnected from the power socket.
EXTERIOR
Clean the outside of your appliance and its viewing window with a damp cloth or a
sponge. Take out the bread pan before you start cleaning. If necessary, you can clean
the exterior of the appliance with a mild detergent.
INTERIOR
Gently clean the inside of the appliance with a lightly damp cloth. Be careful when
cleaning the heating element.
BREAD PAN
You can clean the bread pan with warm water. Be careful not to damage the non-stick
coating. In case the kneading paddle gets stuck, allow the bread pan to cool down
completely. Next, gently pour a little bit of warm water into the bread pan until the
kneading paddle is under water. The sticky bits will dissolve and you will be able to
remove the kneading paddle easily.
Never use cleaning products or dishwashing brushes, for they may damage the non-
stick coating of the bread pan. The bread pan must not be cleaned in the dishwasher.
HOW TO BAKE A DELICIOUS BREAD:
A FEW PRACTICAL SUGGESTIONS
53

Publicité

Table des Matières
loading

Table des Matières