EcoNet RETST800SYS Guide De L'utilisateur page 27

Wiring Remote Temperature Sensor
The EcoNet Smart Thermostat is optimized to work with the Aprilaire 8051 Temperature Sensor (10K thermistor).
Use the S1 and S2 terminals on the wall plate terminal block. Only one remote temperature sensor can
be supported.
Basic Settings
80 80
Set Point Deadband 2º F
Resume Schedule Group 1
71 75 36
Temperature Offset 0.0º F
Relative Humidity Offset 0.0 %
Room Sensor Selection Internal
Home Away
Proximity Sensing? No
Refrigeration
Cooling to
Smooth Arrival Enabled? No
65 34 70
BACK
The following table shows the correct resistance at various ambient temperatures without the sensor wires
attached to the thermostat.
Temperature (°F)
30
40
50
60
70
80
90
100
> Return to Table of Contents
Go to Menu > Settings > Basic > Room Sensor Selection. You can choose
!
to have the system function based on the temperatures measured by the
internal sensor of the thermostat, the remote sensor or the average between
the two sensors.
44% 44%
MORE UNITS
Resistance (kΩ)
34.6
26.1
19.9
15.3
11.9
9.4
7.4
5.9
EcoNet Smart Thermostat User Guide
®
27