ASSEMBLING
•
Assemble the appliance completely and make all required adjustments prior to operation.
•
Follow the assembly and operation instructions closely. Use the figures as visual guide.
•
Pay attention to small parts such as screws and nuts that are loosened or removed for assembly or during adjustments. Keep them safe in order to avoid
losing them.
•
The appliance is large. Assemble with two people.
WARNING!
Use the appliance only after it has been completely assembled and adjusted! Do not use it in collapsed position!
Step 1
Mount the wheel assembly on the base plate.
Fasten the wheel assembly to the base plate using 4pcs M6x12 screws CC and 4pcs M6 nuts BB.
Step 2
Insert the pin of the base in the hole of the lower pole and press to secure the pins. Use 4pcs M5x10 screws AA to secure the lower pole and base plate.Insert the
pins of the middle plate into the holes and press them to secure. Use 4pcs M5x10 screws AA for fastening.
Note: The middle plate must match the bottom plate.
The magnet side must be opposite with wheels side.
Step 3
Place the Burner assembly onto the middle plate. Use 8pcs M5x10 screws AA to secure it .
Step 4
Insert the 4 upper pole into the burner side pole and secure them together with 8pcs M5x10 screws AA.
Step 5
Insert the glass tube.The rubber ring faces downward.
Step 6
Attach the upper plate with emitter screen with 3pcs M5x10 screws AA.Attach the emitter screen assembly on the upper pole and secured with 8pcs M5x10 screws AA.
Step 7
Peel the blue film from the reflector.
Place the four reflector panels as a circle.Insert 4
pcs screws GG into the screw holes at outer side. Fix the screws with Nuts HH. Connect panel with middle ring.
Use screws GG and Nuts HH to fix it.
Step 8
Place the 3pcs M6x60 studs DD into the hole of emitter screen
Put 3pcs washers FF onto the studs.Tighten reflector with Wing Nuts EE and washers FF.
Step 9
Attach the side panels to the tank body with 24pcs M5x10 screws AA.
Step 10
Hook the protective grid and fasten on top
with 4pcs Screws AA and 4pcs Wrench II.
Step 11
Connect gas hose with burner. Ensure tight position.
Note: Run a tightness/leak test.
The injector attached to this unit is not intended for removal. The injector is factory assembled. It is forbidden to change this device from one gas pressure
to another pressure. Do not connect gas cylinder directly to the unit without a regulator. The flexible hose should be approved according to EN16436:2014.
The regulator must comply with standard EN16129:2013, the outlet pressure of the regulator should correspond to the values on the nameplate. The replaced
regulator must comply with the specification listed in the technical data according to the national regulations.
Step 12
Insert front door and close it.
OPERATION
NOTES:
• Ensure the a AA battery (Not included) is installed behind the igniter button.
The anode (+) side of battery must face out.
TO TURN ON THE HEATER
1. Turn ON the valve of the gas supply cylinder completely.
2. Push control knob in at the OFF position then turn counter-clockwise to Pilot position.
3. Push the control knob in, hold it for 30 seconds. Press the igniter button several times to light the burner. Release the control knob after the burner lights. The
flame is visible through the viewing hole. The control knob can be released after the flame lights. If the flame does not light or it goes out, REPEAT STEP 3.
4. Turn the control knob to the desired temperature position.
11
GB