MaxLite BPHE2-PCSHD Mode D'emploi

Operating Instructions
MaxLite
BayMax Pendant High Bay - Economical
®
(BPHE2-PCSHD / BPHE2-ALREF)
General Safety Information
• To reduce the risk of death, personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards read all
warnings and instructions included with and on the fixture box and all
fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires should be
performed by a qualified licensed electrician.
• DO NOT INSTALL DAMAGED PRODUCT!
Diffuser/Reflector Kit (Sold Separately)
PC Diffuser (BPHE2-PCSHD)
Al Reflector (BPHE2-ALREF)
3
M4*8/M4*16(5pieces)
1. Locate the screw holes on the fixture surface. There should be 5 screw holes for the smaller housing size
(150W or less) and 6 screw holes for the larger housing size.
2. For the smaller housing size, attach the transfer ring on the Diffuser/reflector using 6pcs 8-32 x 1/4 screws as
shown. Disregard this step for the larger housing size.
3. Use the 6pcs M4*8 screws to attach the diffuser/reflector to the fixture surface.
4. Install the drop lens cover on the diffuser/reflector using a fixing ring and secure it by using the spring lock
provided on the ring.
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
1
4
BPHE2-PCSHD / BPHE2-ALREF
NOTE: The PIR sensor will not work
effectively with drop lens.
MaxLite Part #:
BPHE2-PCSHD
BPHE2-ALREF
BPHE2-PCDRP
BPHE2-TRNSFR
*BPHE2-TRNSFR required for 150W or less
2
8#-32*1/4(6pieces)
Picture is for illustration purposes only.
Your model may vary.
Size (mm)
190 mm x 299 mm (ID)
190 mm x 297 mm (ID)
38.5 mm x 404 mm (ID)
7 mm x 295 mm
Page: 1
REV: 3/22/22