MaxLite RS Serie Manuel D'instructions

Operating Instructions
MaxLite RS Series
®
General Safety Information
• To reduce the risk of death, personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards read all
warnings and instructions included with and on the fixture box and all
fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires should be performed
by a qualified licensed electrician.
• For Residential installation: If you are unsure about the installation or
maintenance of the luminaires, consult a qualified licensed electrician and
check your local electrical code.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet
metal or other sharp objects.
• Only those open holes indicated in the photographs and/or drawings may be
made or altered as a result of kit installation. Do not leave any other open holes
in an enclosure of wiring or electrical components.
• DO NOT INSTALL DAMAGED PRODUCT!
WARNING:
• Suitable for Dry or Damp location
RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical
Code and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
• WARNING - Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaires
electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
• WARNING - Risk of fire or electric shock. Install this kit only in the luminaires that have the construction
features and dimensions shown in the photographs and/or drawings and where the input rating of the
retrofit kit does not exceed the input rating of the luminaire.
• WARNING - Risk of fire or electric shock. Luminaire wiring and electrical parts may be damaged when
drilling for installation of LED retrofit kit. Check for enclosed wiring and components.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing
luminaire from carton, installing, servicing or performing
maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as
these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can burn away
from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS.
Models: RS Series
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
RS Series
Picture is for illustration purposes
only. Your model may vary.
Installation video available at:
https://tinyurl.com/rs-seriesvideos
Included in the box:
• Retrofit Reflector
• Installation Brackets
• Installation Instructions
• Lens
• Hardware pack with
screws and quarter turn
• Label
Page: 1
REV: 12/20/22