Operating Instructions
MaxLite LED FLAT PANEL RETROFIT KIT (1x4, 2x2, & 2x4)
®
General Safety Information
• To reduce the risk of death, personal injury or property
damage from fire, electric shock, falling parts,
cuts/abrasions, and other hazards read all warnings and
instructions included with and on the fixture box and all
fixture labels.
• Before installing, servicing, or performing routine
maintenance upon this equipment, follow these general
precautions.
• Commercial installation, service and maintenance of
luminaires should be performed by a qualified licensed
electrician.
• For Residential installation: If you are unsure about the
installation or maintenance of the luminaires, consult a
qualified licensed electrician and check your local
electrical code.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and grounded UL Listed troffer housing.
WARNING: RISK OF FIRE OR ELECTRIC SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and any
applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
• Install this kit only in luminaires that have the construction features and dimensions shown in the
photographs and/or drawings and where the input rating of the retrofit kit does not exceed the input
rating of the luminaire.
• Do not make or alter any open holes in an enclosure of wiring or electrical components during kit
installation.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
CAUTION: RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing,
servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing
material, as these may be hazardous to children.
CAUTION: RISK OF FIRE
• Keep combustible and other materials
that can burn away from luminaire and
lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS.
Operating characteristic:
Voltage input: 120/277V 50/60 Hz
Operating temp: -40°F to 104°F
Models: FPR Series
© Copyright 2019. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Included Parts:
• 1pcs - FPR Series Fixture
• 2pcs - Trim pieces
• 1 Set - 182 m/f connectors
• 1 Set - Black/White/Green Wires • 1pcs - Relamping Label
FPR Series
• 2pcs - Brackets
• 1 Pack - Safety Cable
• 2pcs - Wire Caps
Page: 1
REV: 3/27/19