MaxLite FRK Serie Mode D'emploi

Operating Instructions
MaxLite Round Retrofit Kit
®
General Safety Information
• To reduce the risk of death, personal injury or property damage from fire, electric shock,
falling parts, cuts/abrasions, and other hazards read all warnings and instructions
included with and on the fixture box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon this equipment,
follow these general precautions.
• Commercial installation, service and maintenance of luminaires should be
performed by a qualified licensed electrician.
• DO NOT INSTALL DAMAGED PRODUCT!
WARNING - Risk of fire or electric shock. LED Retrofit Kit installation requires
knowledge of luminaires electrical systems. If not qualified, do not attempt
installation. Contact a qualified electrician.
WARNING - Risk of fire or electric shock. Install this kit only in luminaires that have the construction
features and dimensions shown in the photographs and/or drawings and where the input rating of the
retrofit kit does not exceed the input rating of the luminaire.
Only those open holes indicated in the photographs and/or drawings may be altered as a result of kit
installation. Do not leave any other open holes in an enclosure of wiring or electrical components.
WARNING - To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
THIS RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE SUITABILITY OF
THE COMBINATION SHALL BE DETERMINED BY AUTHORITIES HAVING JURISDICTION.
"THIS LUMINAIRE HAS BEEN MODIFIED TO OPERATE LED LAMPS. DO NOT ATTEMPT TO INSTALL OR OPERATE
FLUORESCENT LAMPS IN THIS LUMINAIRE," Shall be marked on the retrofit luminaire where readily visible by the
user during normal maintenance including relamping. Affix the field applied labelonto the luminaire.
WARNING: RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and any
applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION: RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing,
servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION: RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS.
• Disconnect power and allow fixture to cool
before handling fixture.
FRK Series
Models:
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Picture is for illustration purposes
only. Your model may vary.
Model Number: Specific Target Luminaire:
FRK10X3-9XXZ/V4 4.3" Dia. X 2.5" depth
FRK17X4-9XXZ/V3 8.3" Dia. X 2.5" depth
FRK23X5.5-9XXZ/V3 8.3" Dia. X 2.5" depth
FRK28X7-9XXZ/V3 9.2" Dia. X 3.5" depth
FRK Series
Page: 1
REV: 09/08/22