MaxLite SDB Serie Manuel Du Propriétaire

Operating Instructions
MaxLite Slim Downlight Baffle Style
®
General Safety Information
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• To reduce the risk of death, personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards read all
warnings and instructions included with and on the fixture box and all fixture
labels.
• Commercial installation, service and maintenance of luminaires should be
performed by a qualified licensed electrician.
• For Residential installation: If you are unsure about the installation or maintenance
of the luminaires, consult a qualified licensed electrician and check your local
electrical code.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and grounded UL
WARNING:
listed junction box.
RISK OF ELECTRICAL SHOCK
• Turn off the electrical power at fuse or circuit breaker box before wiring fixture to power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and
any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION:
• Don't replace any accessory to prevent from dropping, electric shock or fire. Etc.
• Don't touch the lamp when in use.
• Always switch off the mains supply. 5-10 minutes later to
replace the lamp after the used lamp has cooled down.
• Lamps should only be used in a protective shield!
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when
removing luminaire from carton, installing, servicing
or performing maintenance.
• Avoid direct eye exposure to the light source while
it is on.
• Account for small parts and destroy packing material,
as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials
that can burn away from luminaire.
• MIN 75°C SUPPLY CONDUCTORS.
Models:
• SDB Series
Input Rating: 120V, 60hz, Triac dimming
Operating Temperature: -4°F to 104°F
Wet Location Rated
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com
(-20C° to 40°C)
Picture is for illustration purposes only.
Your model may vary.
Included parts:
• 1pcs - SDB fixture
• 3pcs - P3 connector
with connection box
• 1pcs - installation manual
• 1pcs - hole size template
Length Width
Type
(inch) (inch)
4 inch 5.04 5.04
6 inch 7.17 7.17
8 inch 9.29 9.29
Hole cut size:
4" Round LED (4-1/3")
6" Round LED (6-1/3")
8" Round LED (8-1/4")
SDB Series
Required tools:
• Saw
• Measuring tape
• Electrical wiring (use type
and gauge suitable for
application to connect the
fixtures
Height Weight
(inch) (LB)
1.42 1.10
1.42 1.32
1.42 1.76
Page: 1
REV: 11/12/20