R&G FP0151 Instructions De Montage page 2


Passer l'entretoise avec le fausser large dans le six pan creux du coté droit de l'axe avant.

Passer un écrou et une rondelle sur l'axe (l'extrémité avec le filetage le plus court), engager
l'écrou se façon à ce que l'insert en plastic de l'écrou soit complètement engagé.

Passer l'axe avec écrou et rondelle à travers chaque bobine et à travers l'entretoise d'axe (du coté
droit) tout juste insérée de façon à ce que le diamètre le plus large se place dans le contre alésage
dans la face arrière de la bobine.

Placer l'entretoise restante avec le fausser le plus petit autour de l'extrémité gauche de l'axe de
façon à ce que plus petit fausset se place du coté gauche de l'axe (pour que le diamètre le plus
large se place dans le contre alésage sur la face arrière de la bobine).
 Passer une rondelle et un écrou du kit sur le filetage puis serrer jusqu'à ce que les 2 écrous soient
engagés dans le nylon et que les longueurs dépassant de chaque coté soient identiques. NE PAS
TROP BLOQUER – les écrous fixent l'ensemble correctement.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The
Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those
in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for
its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify
any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the
motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained otherwise
than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be
liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or
the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were
purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-
sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value
exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns of
discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty
goods.
Unit 5K, Blacknest Industrial Park, Blacknest Road, Alton, Hampshire, GU34 4PX
Tel: +44 (0)1420 521100 Fax: +44 (0)1420 521101
OUTILS REQUIS

Clé à douille 2x 13mm
Issue 1 (NSY) 20/01/2014
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
www.rg-racing.com Email: info@rg-racing.com