Inventum AKP6000RVS Mode D'emploi page 20

2
appliance description
1. Inner chimney
2. Outer chimney
3. Cooker hood
4. Controls
5. Metal grease filters - 2 or 3,
depending on the model
6. Lighting (LED spots 2 x 3.0W)
3
before the first use
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the
packaging material. Keep the material (plastic, polystyrene and cardboard) out of reach of children. Check the appliance
after unpacking for any damage, possible from transportation. Place the appliance on a flat and stable surface.
This appliance should be installed and connected to the power supply by a recognized fitter who is familiar with, and works
according to the correct safety regulations.
How to install the appliance, is instructed in the installation instructions (chapter 7).
The appliance must be connected with a properly installed fused socket. The power supply (AC) and voltage at the
operating point must correspond with the details on the rating label of the appliance.
EXTRACTION SYSTEM
This cooker hood can be connected in two ways: to a duct or as a recirculation hood. Install the cooker hood according to
the instructions depending on your choice.
VENT OUTSIDE - to a duct, the cooking vapours extracted by suction are
carried outside, once the grease particles have been filtered. This is the
best method.
RECIRCULATE - as a recirculation hood, the grease particles and the smell
in the extracted vapours are filtered. The air that has been sucked in is not
carried outside but recirculates in the kitchen. In this case you must have a carbon
filter fitted.
Attention! The carbon filters are not included. You need to order these separately.
Order the accessories at your supplier or at the Inventum spare parts webshop.
2 CARBON FILTERS for model AKP6000RVS - article number KB62
3 CARBON FILTERS for model AKP9000RVS - article number KB93
20
• English
1
2
6
3
4
5