Würth ABH 18 COMPACT Traduction Des Instructions De Service D'origine page 19

hazardous situation.
Keep handles and grasping surfaces dry, clean and free from
oil and grease. Slippery handles and grasping surfaces do not
allow for safe handling and control of the tool in unexpected
situations.
Battery tool use and care
A charger that is suitable for one type of battery pack may create
packs. Use of any other battery packs may create a risk of injury
When battery pack is not in use, keep it away from other
metal objects, like paper clips, coins, keys, nails, screws or
other small metal objects, that can make a connection from
one terminal to another. Shorting the battery terminals together
Under abusive conditions, liquid may be ejected from the
with water. If liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause irritation or burns.
temperature.
cause explosion.
Follow all charging instructions and do not charge the battery
instructions. Charging improperly or at temperatures outside the
Service
using only identical replacement parts. This will ensure that the
safety of the power tool is maintained.
Never service damaged battery packs. Service of battery packs
should only be performed by the manufacturer or authorized
service providers.
Hammer Safety Warnings
Safety instructions for all operations
Wear ear protectors. Exposure to noise can cause hearing loss.
Use auxiliary handle(s), if supplied with the tool. Loss of
control can cause personal injury.
Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring.
could give the operator an electric shock.
Safety instructions when using long drill bits with
rotary hammers
Always start drilling at low speed and with the bit tip in
contact with the workpiece. At higher speeds, the bit is likely to
bend if allowed to rotate freely without contacting the workpiece,
resulting in personal injury.
Apply pressure only in direct line with the bit and do not apply
excessive pressure. Bits can bend, causing breakage or loss of
control, resulting in personal injury.
Wear a dust mask.
Some applications may produce a considerable amount of dust,
such as impact and diamond core drilling. Use a dust collection
device such as a vacuum cleaner to collect the dust.
Secure your workpiece with a clamping device. A workpiece
clamped with clamping devices or in a vice is held more secure
than by hand.
Always wait until the product has come to a complete stop before
placing it down. The tool insert can jam and lead to loss of control
over the power tool.
Do not open the battery. Danger of shortcircuiting.
Protect the battery against heat, e.g., against continuous intense
In case of damage and improper use of the battery, vapours may
be emitted. Provide for fresh air and seek medical help in case of
complaints. The vapours can irritate the respiratory system.
Use the battery only in conjunction with your Würth power
tool. This measure alone protects the battery against dangerous
overload.
Use only original Würth batteries with the voltage listed on the
nameplate of your power tool. When using other batteries, e. g.
imitations, reconditioned batteries or other brands, there is danger
of injury as well as property damage through exploding batteries.
Use only original Würth accessories.
Residual Risks
Even when the product is used as prescribed, it is still impossible to
completely eliminate certain residual risk factors. The operator should
pay particular and additional attention to these points in order to
reduce the risk of serious personal injury.
Injury to hearing – Wear suitable ear protection and limit
exposure.
Injury to sight – Wear protective eye shields or goggles when
using the product.
Injury caused by vibration – Limit exposure and follow the
instructions on risk reduction in this manual.
Electric shock after contact with hidden wires – Hold the product
only by insulated surfaces.
Respiratory injury from dust created by operating the product –
Wear suitable protection depending on type of dust.
Cordless rotary hammer
Article number
Voltage
Chuck
Suitable for SDS plus
No load speed
Maximum drilling capacity in
concrete
Maximum drilling capacity in wood
ABH 18 COMPACT
5701 432 00X
18 V/DC
1.5 - 13 mm
0-1400 min
-1
26 mm
30 mm
19