Würth ABH 18 COMPACT Traduction Des Instructions De Service D'origine page 20

Maximum drilling capacity in metal
Impact energy
Rated of percussion
Chuck neck diameter
Weight (According to EPTA
procedure 01/2014)
Weight - not incl. battery pack
Ambient operating and storage
temperature for the tool and battery
pack
(Product performance may drop
below 0°C)
Recommended ambient charging
temperature
Recommended battery type
Recommended charger
Know Your Product
See page 3.
1. SDS chuck
2. Mode selector
3. Direction of rotation selector
4. Trigger switch
5. Handle, insulated gripping surface
6. Battery pack
7. Auxiliary handle, insulated gripping surface
8. Depth guide rod clamp
9. Depth gauge
10. Drill chuck
Intended Use
The product is intended for hammer drilling in concrete, brick and
stone, as well as for light chiselling work. It is also suitable for drilling
without impact in wood, metal, ceramic and plastic.
For damage caused by usage other than intended, the user is
responsible.
Symbols
Read all safety warnings and all instructions.
Warning
V Volts
Direct current
13 mm
2.4 J
0-4800 min
-1
43 mm
3.82 kg (4.0 ah) - 3.92 kg
(5.0 ah)
3.14 kg
-15 - 40°C
5 - 40°C
LI 18V/2 Ah BASIC
LI 18V/4 Ah BASIC
LI 18V/5 Ah BASIC
ALG 18/4 BASIC
A battery that is new or has not been used for a longer period does
ALG 18/6 FAST
not develop its full capacity until after approx. 2 – 3 charging/
discharging cycles.
Do not place down the battery on radiators or expose it to intense
sunlight for longer periods; temperatures above 50 °C cause damage.
Keep the contacts/terminals of the charger and replaceable battery
clean. For optimal service life, fully charge the battery after use.
Dusts from materials such as lead-containing coatings, some wood
types, minerals and metal can be harmful to one's health. Touching
or breathing-in the dusts can cause allergic reactions and/or lead to
respiratory infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are considered carcinogenic,
especially in connection with wood-treatment additives (chromate,
wood preservative). Materials containing asbestos may only be
worked on by specialists.
Observe the relevant regulations in your country for the materials
being worked on.
If the product should fail despite the care taken in manufacturing and
testing procedures, repair should be carried out by a Würth master-
Service.
In all correspondence and spare parts orders, please always include
the article number given on the type plate of the machine.
No-load speed
min Revolutions or reciprocations per minute (rpm)
–1
CE conformity
British Conformity Mark
EurAsian Conformity Mark
Regulatory Compliance Mark (RCM). Product
meets applicable regulatory requirements.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Battery
Dust Extraction
Provide for good ventilation of the working place.
Maintenance and Cleaning
Disconnect the plug from the power source and/or the battery
pack from the power tool before making any adjustments,
changing accessories or storing power tools. Such preventive
safety measure reduce the risk of starting the power tool
accidentally.
For safe and proper working, always keep the product and
ventilation slots clean.
20