Publicité
Les langues disponibles
Les langues disponibles
Stability Bracket
If the cooker is fitted with a flexible connection, a stability bracket should be fitted to engage in the back
of the cooker. A stability bracket can be bought from your local supplier.
note: Ensure that the rear spacer is installed prior to fitting the stability bracket.
A stability bracket can be fitted as follows:
1. Place the cooker in the position and draw a PENCIL LINE level with the front edge.
2. Mark the centre of the cooker to give the CENTRE LINE for the bracket.
3. Remove the cooker and mark off 450mm from the PENCIL LINE to locate the front edge of the low-
er bracket.
4. Fix the bracket to the floor. Measure from floor level to engagement edge in the back of cooker and
add 3mm.
5. Assemble the underside of the top part of the bracket to this height
Front edge
for lower
bracket
DiMensions anD clearances
450 mm
(4)
(3)
(2)
Centre line
Underside of top bracket slots into
engagement edge in back of cooker
Stability bracket
Review stability bracket
location identified on rear
of appliance and position
bracket accordingly
(1)
Pencil line on floor
(5)
Publicité
