Publicité
Les langues disponibles
Les langues disponibles
Before installation
levelling Your cooker
Place a spirit level on a baking sheet onto an oven shelf.
The cooker is fitted with leveling feet (1) Level your cooker to your desired height using the leveling feet
at the front and rear of the cooker.
rear wheels (if fitted)
Adjustment of the wheel height can be made with a screw driver, through the hexagonal hole in the
front plinth
products with cast lid (where fitted)
A 35mm clearance is required from the back of the hotplate to the rear wall, to allow the lid to be
opened fully. To ensure this clearance is maintained, the infill piece (supplied) should be fitted using the
instructions below.
Fix the infill piece to the wall - using suitable screws and wall fixings (not supplied) - and ensure it is
level with the hotplate as shown.
Note: The 35mm clearance dimension should not be reduced.
600mm
35mm
Publicité
