Publicité
Les langues disponibles
Les langues disponibles
Abrasive blades on page 11 and To attach the
cutting blade on page 13 .
•
Make sure to use the correct cutting blade for the
type of operation, see
high speed power cutters on page 11 .
•
Do not cut asbestos material.
•
Always hold the power cutter with 2 hands. Always
hold the product tightly with thumbs and fingers
around the handles. Always hold the rear handle
with the right hand and the front handle with the left
hand.
•
Always be parallel to the cutting blade. Do not be
linearly behind the cutting blade. If there is a
kickback, the power cutter moves in the plane of the
cutting blade.
•
Keep a safe distance to the cutting blade when the
engine operates.
•
Make sure that you are in a stable position during
operation.
•
Keep applicable distance from the object you are
cutting.
•
Do not operate above shoulder height. Use a
platform or scaffold if the cutting operation is above
shoulder height. Do not overreach.
•
Do not operate from a ladder.
745 - 008 - 12.11.2018
Cutting blades for handheld
•
Make sure that the cutting blade is free when the
engine is started.
•
Always monitor the product when the engine
operates.
•
Do not move the product when the cutting blade
rotates.The product has a electrical retarder to
decrease the blade stop time.
•
Make sure that the front ground support is flush with
the work piece at the rear. The blade guard collects
spray and dust and moves them away from the
operator.
•
Cut with full throttle. Keep full rotating speed until the
cutting operation is completed.
•
Push the cutting blade lightly against the object you
are cutting. Do not use force.
•
Align the cutting blade with the cut.
•
Move the cutting blade slowly forward and rearward
to decrease the area between the cutting blade and
the material. This decreases the temperature of the
cutting blade.
•
Do not cut with the kickback zone of the blade, see
Kickback on page 18 .
17
Publicité
