Whirlpool ADN 203B Mode D'emploi page 8

Protect the appliance inner surfaces and plastic parts from fats, acids
•
and sauces. In case of accidental spills – immediately clean with warm
soapy water or dishwashing detergent.
surfaces.
Regularly clean the hermetic gaskets of the doors. Wipe dry.
•
REGULARLY CLEAN THE THAW WATER CHANNEL SPACE WITH A
•
SPECIAL CLEANER 8 FOR THAT PURPOSE (see fig. 1, page 1).
At least once a year clean dust away from the back part of the
•
appliance body and the compressor. A soft brush, electrostatic cloth
or vacuum cleaner may be used for cleaning.
DO NOT use detergents containing abrasive particles, acid, alcohol or benzene for
•
cleaning the appliance inner and outer surfaces. DO NOT use for cleaning cloths or
sponges that have coarse surfaces intended for scrubbing. Outer of the doors – glass –
clean with agents intended for glass cleaning.
IF THE APPLIANCE IS TO BE LEFT SWITCHED OFF FOR AN EXTENDED PERIOD, LEAVE
•
ITS DOORS OPEN.
OPERATION PROBLEMS AND THEIR SOLUTIONS. What if ...
The appliance is plugged in to the mains but it does not work and the
•
electricity supply voltage indicator is not illuminated. Check that your house
electricity supply installations are in order. Check that the plug is correctly inserted into
the electricity supply socket.
The noise has become louder. Check that the appliance is standing stable, on a level
•
place. To make it level, regulate the front feet. Check if the appliance is not touching
any furniture, and that no part of the refrigeration system at the back part of the
appliance body is touching the wall. Pull the appliance away from any furniture or walls.
Check that the cause of increased noise isn't due to bottles, cans in the appliance that
might be touching each other.
Water has appeared at the bottom of the refrigerator compartment. Check
•
whether a thaw water channel space isn't blocked. Clean the thaw water channel space
with a cleaner intended for that purpose.
Water has appeared under the appliance.
•
slipped off the compressor. Place the tray on top of the compressor.
When the appliance door is opened, the rubber sealing gasket pulls out. The
•
gasket is smeared with sticky foodstuffs (fat, syrup). Clean the sealing gasket and the
groove for it with warm water containing soap or dishwashing detergent and wipe dry.
Put the rubber sealing gasket back into the place.
High temperature in appliance, the compressor operation pauses are short.
•
Ascertain whether the appliance door/doors are shutting tightly, whether the door
wasn't kept open longer than necessary when taking out or putting in foodstuffs or
whether a large amount of warm food was placed in the appliance.
The top of the appliance has condensation on it. The ambient relative air humidity
•
is above 65 %. Ventilate the room where the appliance stands and if possible remove
the cause of the humidity.
Remarks on the appliance operating noise. As the appliance operates and
goes through the freezing cycle, various noises will be emitted. This is normal and
is not a sign of any malfunction.
Wipe dry inner and outer
The thaw water collection tray has
7