Publicité
Les langues disponibles
Les langues disponibles
Quick reference
SYMPTOM
CAUSE
The mower does not
There is no power.
charge.
Something is clogging in the blade
disc creating friction and increasing
power consumption.
Landroid Vision is starting
Landroid Vision is shaking heavily be-
to have shorter run-times
cause the blade disc is unbalanced.
between charges.
The battery may be exhausted or old. Replace battery.
The working time is up.
The clock is not set to the correct
time.
Landroid Vision is not
Programmed cutting times for Lan-
operating at the correct
droid Vision are not correct.
time.
The percentage of weekly operating
time set through App has changed.
The direction of the charging base is
incorrect.
Landroid Vision can not
There are obsacles in front of the
find the charging base.
charging base.
The QR code is sheltered.
Environmental influences.
Landroid Vision cannot
correctly dock with the
Poor connection caused by debris on
charging pile.
the charging strip.
The green light on the
charging pile turns
The charging base is overheating or
on before charging is
overcooling.
complete.
Obstacles, such as twigs and bran-
ches may be lodged under Landroid
Vision.
Landroid Vision wheels
skid or repeatedly slip.
The lawn is too wet.
Low grip of Landroid Vision drive
wheels.
The slope is steeper than 30 % (17
Landroid Vision slips out
of its working area.
Recognition error.
There is grass whose height is higher
than 5.9 in. (15cm).
SOLUTION
Check the power cord is connected properly to the charger
and the charger is connected to a suitable power supply.
Make sure both the charging strips on the mower touch the
center of the charging contacts on the charging pile.
Take off the blade disc and clean it. Maybe the grass is too
high and too thick.
Check the blade disc and blades, remove debris and forei-
gn objects from the blades and blade disc.
Replace the blades with a new set.
Reset the working time.
Set the clock to the correct time.
Change the time settings for the mower to start and stop.
Set the correct percentage through App.
Make sure Landroid Vision dock right towards the charging
base and departures in anti-clockwise direction.
Please remove the obstacles within the 6.5 feet (2 m) in front
of the charging base.
Make sure the QR code is clear and that there is nothing
directly on it or above it.
Restart Landroid Vision.
Clean the contact pins located on the charging pile and the
charging strip on Landroid Vision using a cloth.
Place the charging base in a shady area or wait until it rea-
ches the normal temperature.
Remove objects from underside of Landroid Vision.
Exclude the wet or soft ground areas by using the magnetic
strip or by creating a non-grass pathway that is more than 2
in. (5 cm) wide until the lawn is dry again.
Please check the wheels are clean and free of mud in order
to have the maximum grip possible.
Exclude the sloped area by using the magnetic strip or by
).
creating a non-grass pathway that is more than 2 in. (5 cm)
o
wide directly beside the slope.
Remove the obstacle if there is one. Using the magnetic
strip or by creating a non-grass pathway that is more than
2 in. (5 cm) wide on the lawn edge ensure that the mower
functions correctly.
Trim the grass to below 5.9 in. (15cm). Lay magnetic strips
or set up a 2 in. (5 cm) non-grass pathway if there are steps,
cliffs or a pond below the grass.
EN
33
Publicité
