Honeywell MHMP909D1342 Instructions D'installation

BEFORE INSTALLATION
The MP909D Pneumatic Damper Operator can be mounted in
any position, externally or internally.
Pneumatic air connection is sized for 5/32-inch (4 mm) or
1/4-inch (6 mm) O.D. plastic tubing.
Installation requires no special tools.
INSTALLATION
Ball Joint Type Linkage
1. Refer to Fig. 1 for dimensions.
2. Select mounting location.
3. Using the mounting bracket as a template, mark two
mounting holes.
4. Drill or punch two mounting holes and secure mounting
bracket with screws provided.
5. Install operator on mounting bracket with two No. 8 x 1/2
self-tapping screws (see Fig. 2).
6. Screw locknut and motor shaft balljoint onto operator
shaft (see Fig. 3).
7. Tighten locknut against motor shaft balljoint.
8. Install crankarm balljoint on crankarm.
9. Secure crankarm to damper drive axle.
10. Cut 5/16-inch pushrod to length.
11. Slide pushrod onto crankarm balljoint and motor shaft
balljoint.
12. Tighten balljoint setscrews.
13. Push plastic tubing from controller branch line onto
operator inlet port.
NOTE: NOTE:After tubing is connected, do not
attempt to remove it. If it must be
disconnected, cut the tubing and reconnect
with a barb coupling.
® U.S. Registered Trademark
Copyright © 2000 Honeywell Inc. • All Rights Reserved
Pneumatic Damper Operator
2-3/8
(61)
1/2 (13)
Fig. 1. MP909D approximate dimensions in in. (mm).
OPERATOR SHAFT
LOCKNUT
MOTOR
SHAFT
BALLJOINT
5/16 in.
PUSHROD
SETSCREW
INSTALLATION INSTRUCTIONS
1/4 DIA (6)
5-11/16 (145)
OPERATOR
OPERATOR
SHAFT
SELF-TAPPING
SCREW
Fig. 2. Operator mounting.
CRANKARM
BALLJOINT
DAMPER
AXLE CRANKARM
Fig. 3. Ball joint linkage.
MP909D
3/8-16 UNC-2A
13/16 (20) LONG
MIN.
OR
1-1/16
1-3/16
(27)
(46)
C484-2
MOUNTING
BRACKET
M16439
INLET
PORT
MOUNTING
BRACKET
M16438
95- 7175EF