HQ Power VDPDP134D Notice D'emploi page 4

TEMPORARILY ADJUSTING THE CHANNEL INTENSITY
TEMPORARILY ADJUSTING THE WHOLE INTENSITY
6.2 BASIC MENUS
DMX FAIL
V. 03 – 22/09/2014
VDPDP134D
Press the channel button to select the desired channel intensity, each press
will change the intensity by one factor.
Pressing the button for two seconds changes the channel intensity quickly.
By pressing the ESC button, the changing direction of the channel intensity
will be reversed.
Press the UP/DOWN button to select the desired intensity; each button press
will change the intensity by one step. Holding the button for two seconds, the
channel intensity will change quickly.
In the start menu, press the menu button to enter the basic menus system.
There are 5 menus: DMX fail, phase correction, DMX address, preheat and
curve.
You can use the UP/DOWN button to scroll through the menus. Press the ESC
button to leave the basic menus system.
1. Press the UP/DOWN button to scroll to the DMX fail menu.
2. Press the MENU button, to enter the sub menu system. You can use the
UP/DOWN button to select hold/analog/prog. 1-12.
Hold]: last received DMX signal is held
o
[Analog]: The analogue input is (0-10V) is activated.
o
[Progr. 1-12] starts internal programs 1-12.
o
3. If you select "hold" or "analog", you can press the ESC button to exit.
4 ©Velleman nv