Publicité
7. REMOTE RESTARTING OF GATEWAY
8. REMOVAL OF EXISTING Wi-Fi NETWORK FROM GATEWAY
To remove an existing Wi-Fi network from gateway and register a new Wi-Fi network, the following steps need to be taken:
1. The refrigerator must be unplugged.
2. Hold down the gateway tab while plugging in the refrigerator. The lamp blinks quickly indicating it is in set up mode. Let go of the tab.
3. Retap and hold the tab down for at least 5 seconds. Let go. The lamp blinks 2 times/second: The data of the old Wi-Fi network has just been erased and it is in new Wi-
Fi connection standby mode.
4. Follow the steps in
Connecting the IOTW gateway to WI-FI – Provisioning
9. ALTERNATIVE Wi-Fi CONNECTION
If you are unable to connect by following the steps in paragraph
1. Tap and hold the gateway tab down while plugging in the refrigerator. The lamp blinks quickly indicating it is in set up mode. Let go of the tab.
2. Retap and hold the tab down for at least 20 seconds. Let go. The lamp blinks 3 times/second: Gateway is in new Wi-Fi connection standby mode via the alternative Wi-
Fi connection method.
3. Find the BLE Name on the refrigerator label.
4. Download the ESP BLE Provisioning app
enter the PIN: abcd1234 when prompted.
5. You will then be taken to a list of available Wi-Fi networks. Enter the desired network. The gateway's connection to the available Wi-Fi network has been successfully
completed.
6. The gateway lamp blinks 1 time/second which means it is in platform account connection standby mode. Follow the steps described under
gateway to the Cortex account
If connection fails due to your smartphone's incompatibility, try downloading the app on another mobile phone. A once-off Wi-Fi connection is necessary and you will not be
required to repeat the procedure, unless you want to change the gateway Wi-Fi network. This app is only used for this procedure and not for monitoring and controlling the
device.
Made in Greece.
The device is covered by a two-year good performance warranty. The warranty applies only if the instructions for use have been observed. The device must only be tested and repaired by an
authorised technician. Warranty only covers the replacement or repair of the device. KIOUR reserves the right to adjust its products without notice.
KIOUR Private Company implements a Quality Management System according to the Standard EN ISO 9001: 2015 with registration number 01013192.
392 Mesogeion Avenue, Agia Paraskevi 153 41 T: 210 6533730 info@kiour.com www.kiour.com
To restart the gateway via the Cortex platform, the following steps need to be taken:
1.
Tap the Set up my network tab at the bottom of the main page.
2.
In the Gateway list window, click
tab. Wait 10 seconds until the Status column changes to
restarted.
Connecting the IoTW gateway to Wi-Fi –
and grant access. Tap the Provision new device tab. From the list that appears, search for the BLE Name, select it and
to link gateway to your account.
next to the gateway you would like to restart and then the
to register the new Wi-Fi.
Provisioning, the following steps need to be taken:
Online
at which time the gateway has been successfully
Restart
Connecting the IoTW
V1.1.2
5
Publicité
