KRESS Mission KR133E Mode D'emploi page 17

Mission does not
TM
give an alarm when
it is outside the Geo
fence.
Mission still works
TM
when it is outside the
Geo fence.
Mission works
TM
normally but the
communication
between Mission
TM
and smartphone
does not work
properly.
Mission is unable
TM
to achieve real time
positioning or the
location of Mission
TM
cannot be updated in
real-time.
NOTE:
1. The battery of GeoTrace must be replaced by the service agent.
2. Make sure Mission
TM
3. The GeoTrace needs be renewed once SIM subscription fee expired.
Environmental protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
The software of Mission
the latest.
There is a small tolerance area
immediately outside the perimeter
set for GeoTrace.
The GeoTrace is powered off.
Geo Fence is not set, or radius of
Geo Fence is not set.
Mission is powered off.
TM
Geo Fence is not set, or radius of
Geo Fence is not set.
Geo Fence is not enabled.
The cellular network coverage of
GeoTrace is weak.
The GeoTrace is damaged.
The software of Mission
latest.
The Mission App needs to be
TM
updated.
The SIM of the GeoTrace is not
activated.
The GeoTrace is not well connected
to Mission
TM
Mission has no power.
TM
The SIM subscription fee has
expired.
The GeoTrace is designed to update the
positioning every 10 minutes for power
economy. When Mission
TM
power battery capacity, the time interval
of positioning update will be longer.
If Mission has been switched off for
TM
more than 24 hours in the Geo fence
for storage, the GeoTrace is auto
powered off with no GPS signal.
is regularly charged during storage, once every half year is recommended.
itself is not Update the software of the Mission
TM
using the GeoTrace.
Bring Mission
(approximately 30m from the Geo fence) to
verify that GeoTrace is working.
Turn on Mission
it. If it doesn't need to be recharged, Find My
Mission
TM
Mission
TM
(GeoTrace has an inner battery that lasts a
week after the machine is turned off).
Use the Mission
In this case, the alarm will be sent 10mins
after the Mission
Geo fence.
Use the Mission
Check if it has a weak signal. If yes move to
an area with a good signal.
Contact a dealer and get it checked properly.
is not the
TM
Update the software of Mission
Update your Mission
GeoTrace.
Before first use, make sure you have activated
the SIM by following the procedure in the App.
Contacting dealer. Check that the GeoTrace
connector is correctly inserted with a click.
Check if the screen of Mission
illuminated. If not, send Mission
to the charging base for charging or start
emergency procedure to charge it.
Once expired it must be renewed.
has low
This is normal. No action is needed.
outside of the tolerance area
TM
and if necessary recharge
TM
GeoTrace will be recharged by the
battery.
App to set it properly.
TM
is brought outside of the
TM
App to set it properly.
TM
TM
App before using the
TM
is
TM
TM
before
TM
.
17
EN
back