Publicité
Les langues disponibles
Les langues disponibles
1. Fill cooler
Connect one end of a garden hose to the water supply and the other end to the cooler's water supply inlet.
Turn on the water supply. The water flow will automatically shut off when the cooler is full.
2. Plug in cooler
Plug the power cord into a fused or breaker-protected circuit.
3. Turn on pump
Make sure the cooler's drain valve is fully closed. Press the PUMP button on the control panel to turn on
the pump.
4. Adjust water flow
Adjust the flow control valve until a visible flow of water trickles evenly down the cooling media. Make sure
water is not splashing outside of the cooler.
5. Flush new cooling media
Skip this step if you are not using new cooling media.
When starting the cooler for the first time or after replacing the cooling media, run the pump for five hours
without the fan running to flush the new media.
6. Start cooling
Press the COOL button on the control panel to turn on the fan and start cooling. Use the + and - buttons to
adjust the fan speed to your preferred setting.
7. Shut down cooler
Press the OFF button on the control panel to turn off the fan and pump, and then press the DRY button. The
fan will run for one hour to dry out the cooling media and will then turn off automatically. Allow the cooling
media to dry out completely once every 24 hours to prevent algae growth.
Convenient control with the Big Ass Fans app
Download the Big Ass Fans mobile app to control your Cool-Space
device. You can also view maintenance tips and monitor your cooler's water level, water
treatment tablet status, and cooling media status.
2
OPERATION
WWW.BIGASSFANS.COM
© 2023 DELTA T LLC
from your mobile
®
ALL RIGHTS RESERVED.
Publicité
