Télécharger Imprimer la page

Bosch Readyy'y BBHR2 Serie Mode D'emploi page 42

Masquer les pouces Voir aussi pour Readyy'y BBHR2 Serie:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44
en
Congratulations on your purchase of a Bosch vacuum
cleaner from the BBH series.
This instruction manual describes various BBH models,
which means that some of the equipment features and
functions described may not apply to your model. You
should only use original Bosch accessories, which have
been specially developed for your vacuum cleaner, to
achieve the best possible vacuuming results.
Please fold out the illustrated pages.
Your vacuum cleaner
1 Floor nozzle with electric brush
2 Brush roller release button
3 Dirt container
4 Motor protection filter
5 Foam filter
6 Motor unit
7 Floor tool release button
8 Crevice nozzle*
9 Hand-held vacuum cleaner handle
10 Hand-held vacuum cleaner sliding switch
11 Hand-held cordless vacuum cleaner release button
12 Hand-held cordless vacuum cleaner handle
13 Hand-held cordless vacuum sliding switch
14 Battery charging status indicator
15 Dirt container release button
16 Charging cable
17 Brush roller
18 Brush roller guide rod
Before using the appliance for the first
time
1
Fig.
Carefully place the handle onto the main housing
and screw it into place.
2
Fig.
Plug the hand-held vacuum cleaner into the floor
nozzle and lock it into place.
To release the floor nozzle, press the release button
and pull the hand-held vacuum cleaner out of the
nozzle.
42
Charging
!
Caution: Before using the vacuum cleaner for the
first time, the batteries must be fully charged (until
the charging indicator goes out).
3
Fig.
Plug the charging cable into the connection at the
rear of the appliance.
Plug the charging cable plug into the socket.
The charging indicator will light up.
Once the batteries are fully charged, charging will
automatically stop and the charging indicator will go
out, even if the charging cable is still connected to
the mains power supply.
If the charging cable is disconnected from the mains
power supply and then reconnected, the charging
process will start from the beginning again.
It is normal and completely safe for the charger and
the vacuum cleaner to heat up.
Using the hand-held vacuum cleaner
Vacuuming
4
Fig.
Actuate the sliding switch in the direction of the ar-
row.
Controlling the suction level
5
Fig.
Slide the sliding switch into the required position in
order to set the suction power:
Position 1
Suction without the electric brush switched on.
For simple cleaning tasks on hard floors and particu-
larly low operating noise.
The appliance achieves the maximum run time at
this level.
Position 2
Vacuuming at full power and with the electric brush
switched on.
For particularly demanding cleaning tasks. The ap-
pliance achieves a shorter run time at this level.
* Depending on model
1
2

Publicité

loading

Ce manuel est également adapté pour:

Readyy'y bbh2r serieReadyy'y bbh216