Publicité
Les langues disponibles
Les langues disponibles
Dangerous cutting area
Best cutting area
10
MAINTENANCE
IMPORTANT
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
IMPORTANT
Make sure that all nuts, bolts and screws are tight.
Check regularly that the handles are firmly mounted.
IMPORTANT
Use only the replacement parts and accessories of the
initial manufacturer.
10.1 GENERAL INFORMATION
IMPORTANT
Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Use correct clothing, protective gloves and safety
glasses.
10.2 CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth
dipped in neutral detergent.
•
Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or
excessive grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
English
•
10.3 REPLACE THE SPOOL
1. Push the tabs (1) on the sides of the trimmer head
2. Pull and remove the spool cover (2).
Direction of rotation
3. Remove the remaining spool (3).
4. Put the new spool in the spool housing (4).
Make sure that the cutting line is in the guide slot on
the new spool, and is extended approximately 5 in.
before you install the new spool.
5. Put the end of the cutting line through the eyelet (5).
11
Do not spray water onto the motor and electrical
components.
at the same time.
1
3
NOTE
EN
2
1
4
Publicité
