Publicité
Les langues disponibles
Les langues disponibles
KNOW YOUR COMPOUND MITER SAW
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
7-1/4 in. BLADE
A 7-1/4 in. blade is included with the compound miter saw.
It will cut nominal materials up to 2 in. thick by 10 in. wide,
depending upon the angle at which the cut is being made.
BLADE WRENCH STORAGE
See Figure 1.
A blade wrench is packed with the saw. One end of the
wrench is a phillips screwdriver and the other end is a hex
key. Use the hex key end when installing or removing blade
and the phillips end when removing or loosening screws. A
storage area for the blade wrench is located in the saw's base.
BEVEL LOCK KNOB
The bevel lock knob securely locks your compound miter
saw at desired bevel angles. A positive stop adjustment
screw has been provided on each side of the saw arm.
These adjustment screws are for making fine adjustments
at 0° and 45°.
CARRYING HANDLE
See Figure 2.
For convenience when carrying or transporting the miter
saw from one place to another, a carrying handle has been
provided on top of the saw arm. To transport, turn off and
unplug the saw, then lower the saw arm and lock it in the
down position by depressing the lock pin towards the saw
housing.
NOTE: DO NOT perform any cutting operation with the saw
in the locked position.
CROWN INDICATOR
See Figure 1.
For use with the auxiliary fence. To cut crown molding nested
against the auxiliary fence in the upright position, align the
arrow on the crown indicator with the arrow on the pivot
assembly and tighten the slide lock knob securely.
DETENT OVERRIDE
See Figure 3.
The detent override allows the miter table to move freely
to any desired angle. With the miter lock handle loosened
and the detent release lever squeezed (1), pull the detent
override up (2) and release the detent release lever (3) to
bypass the positive stops on the miter scale. To release
the detent override and allow the miter table to engage the
positive stops, squeeze and release the detent release lever.
FEATURES
CARRYING
HANDLE
"D"
HANDLE
SAW ARM LOCKED IN DOWN POSITION
MITER
LOCK HANDLE
DETENT
RELEASE LEVER
9 − English
LED
SWITCH
DETENT
OVERRIDE
3
2
1
LOCK
PIN
BEVEL
LOCK KNOB
Fig. 2
Fig. 3
Publicité
