CASO DESIGN WineDeluxe WD 60 Mode D'emploi page 25

4.3 Appliance ventilation
PLEASE NOTE

The ventilation shaft must be at least 200 cm² in size, measu-
red from the lower ventilation opening to the top of the back
of the appliance.
Options for appliance ventilation
1. Directly above the appliance
2. Above the installation cabinet
3. On the front of the installation cabinet, covered with a decora-
tive grille
1
PLEASE NOTE

If decorative grilles are used, please ensure that the cross-
section of open ventilation equals the total area of the
individual openings in the grille. A cross-section area of 200
cm² is therefore insuffi cient if a ventilation grille is installed.
4.4 Complete overview
1
2
3
4
1
control panel
2
wooden shelf with ball
bearing runners
3
activated carbon fi lter
2 3
4
wooden shelf
5
sealing of the door
6
door frame
4.5 Changing the direction in which the door opens
Door hinges should only be changed by a trained specialist. At
least two persons are required to change the door hinges. If you
want to change the direction which the door opens, you should
do this BEFORE installation.
WARNING
Risk of injury and damage to property

Heavy weight of the door. Only carry out the modifi cation if
you can lift the weight of the door.

Risk of injury if the door falls out! The door may fall out if the
hinges are not screwed in properly. This may result in serious
injuries and damage to the door.
1. Disconnect the appliance from mains power when changing
the door hinges.
2.
Open the door.
3. Remove the hinge covers and screws.
5
6
4. Remove the door and rotate it 180°.
CASO WineDeluxe WD 60
DE
EN
FR
IT
ES
NL
RUS
SE
PT
25