Husqvarna LC 247S Manuel D'utilisation page 82

blade. Remove the blade bolt by turning the bolt
counter-clockwise.
• Make sure the blade bracket is free of damage. Also
check that the blade bolt is undamaged and that the
engine shaft is not bent.
Assembly
• The blade must be mounted with the angled ends
pointing up towards the cover.
• Place the cutter with the friction washer against the
cutter bracket. Make sure the cutter centers correctly
on the shaft.
• Lock the blade with a wooden block. Fit the washer
and tighten the bolt correctly by turning clockwise. The
bolt should be tightened with a torque of 70 Nm.
• Pull the blade around by hand and make sure it
rotates freely.
82 – English
MAINTENANCE
• Test run the machine.
IMPORTANT!
Always exercise care and use your common sense.
Avoid all situations which you consider to be beyond
your capability. If you still feel uncertain about operating
procedures after reading these instructions, you should
consult an expert before continuing. Contact an
authorised service workshop.
Always use genuine parts. For more information, see
the "Technical data" section.
Battery
IMPORTANT!
An exhausted battery must not be disposed of as
household garbage! Leave it at your nearest service
agent or collection point.
The battery is a safety switch and must only be mounted
on the engine when the machine is in use.
The battery is an intelligent 10.8V lithium battery that
must be activated before being used for the first time.
Place the battery into the charger and wait until at least 1
green lamp comes on (10 seconds). The battery can then
be mounted on the engine.
IMPORTANT!
The battery on this model is a safety component.
Always use genuine parts.
Charge the battery.
The battery has an easy-check voltage indicator with
LEDs (1-4).
If the voltage is too low (1 or 0 LEDs lit), place the battery
in the charger and connect to a wall socket (220V, 50Hz).
A flat battery will be fully charged after about 60 minutes.
The battery can be quick-charged for shorter periods
without damage.