Husqvarna LC 247S Manuel D'utilisation page 75

General
IMPORTANT! Prevent accidental starting
!
by removing the ignition cable and,
where appropriate, the start battery/
safety switch.
Handle
Settings
Handle height
• Loosen the lower knobs.
• Slide the knobs to the ends of the grooves on both
sides of the machine.
• Handle height can be set to 2 different positions,
• Adjust to a suitable height.
• Slide the knobs up towards the handle until they stop
and a click is heard.
• Tighten the knobs properly.
Transport position
The handle assembly can be folded to minimize space
needed for transport and storage.
• Loosen the lower knobs.
• Disconnect the starter cord.
• Slide the knobs to the ends of the grooves on both
sides of the machine.
ASSEMBLING AND ADJUSTMENTS
• Fold forward the handle.
Operating position
• Fold the handle to its upright position.
• Slide the knobs up towards the handle until they stop
and a click is heard.
• Screw on the handle with the knob.
• Connect the starter cord.
Cutting height
NOTICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
The machine is equipped with central cutting height
adjustment.
–
English 75