COOKTOP SPECIFICATIONS
Warnings:
This appliance is designed to be built into a housing unit.
-
The installation class is type 3 for gas and type Y for electric parts.
-
Housing units must be designed to withstand temperatures of up to 90°C or over.
-
For correct installation, refer to the relevant paragraph and reference drawings.
-
The use of a gas cooking appliance produces heat and humidity in the room in which it is
installed. Ensure the kitchen is well ventilated: keep natural ventilation openings open, or install
a mechanical ventilation device (extractor hood with exhaust duct). In the case of intensive or
prolonged use of the appliance it may be necessary to provide additional ventilation, for example,
by opening a window, or more efficient ventilation, for example by increasing the hood speed.
This handbook is intended for a several types of cooktop. The typeplate data shown on the back allows you to
verify that it corresponds to your model. The indications provided in the next sections, along with the figure
located at the end of the manual (Fig 1), will help you become familiar with your appliance.
Label:
USING THE COOKTOP
Gas burners
The delivery of gas to the burners is controlled by the knobs shown in fig. 4 that in turn control the taps.
The symbols, depending on the various versions, may be printed on the knobs or on the control panel.
By moving the indicator to coincide with the printed symbols, the following adjustment can be made:
Tap closed, no gas delivery
Maximum capacity, maximum gas delivery
Minimum capacity, minimum gas delivery
Burners ignition
These models are equipped with safety valves which automatically shut off the gas delivery
in the event the burner should, for any reason, go out. To relight the burner, turn the knob to
position "tap closed" and repeat the ignition procedure explained in the following paragraph.
To light one of the burners, turn the gas tap knob to the maximum
delivery position, then press and hold down it for about 4÷5 seconds.
Legend:
(1)
Trade Mark
(2)
Corresponding model
(3)
Technical code
(4)
Customer code
(5)
Power inputs
(6)
Voltage and frequency data
(7)
Country of target market and gas details
(8)
Gas burners power
(9)
Gas burners consumptions
.