Publicité
Les langues disponibles
Les langues disponibles
2) Tighten the filter retainer lock clockwise to secure against the internal filter cage (Fig. 9).
3) Slide the pre-filter onto the assembled cartridge flter ensuring the securing band sits flush
against the metal rim of the cartridge filter. Tighten the jubilee clamp on the pre-filter with a
screwdriver to ensure proper installation (Fig. 10).
4) Optionally, fully fit the dust bag flange onto the inlet stub. The Vacuum cleaner can we be used
with or without dust bags.
IMPORTANT: Check the filter regular for optimal performance. An old or blocked filter
will reduce suction performance.
For Wet Vacuuming:
1) To prepare your vacuum cleaner for wet vacuuming, remove the retainer lock and the dry use
cartridge filter and pre-filter.
2) Carefully install the supplied foam filter over the internal filter cage, making sure the whole cage
is covered (Fig. 11).
WARNING:
DO NOT USE THE CARTRIDGE FILTER FOR WET VACUUMING.
DO NOT USE A DUST COLLECTION BAG FOR WET VACUUMING.
IMPORTANT!
When vacuuming large quantities of liquids, do not immerse the nozzle completely;
leave a gap at the tip of the nozzle to allow air inflow. The machine is fitted with a float valve that
stops the suction action when the container reaches its maximum capacity. You will notice an
increase in motor noise. When this happens, turn off the machine, disconnect from power supply,
and drain the liquid. To continue vacuuming, replace the drainage cap.
13
GB
Publicité
