LG LHTNS2403 Serie Manuel Du Propriétaire page 11

Les langues disponibles

2. Reversing and Reinst alling Refrigerator Door

Using a ¼" socket wrench, loosen and remove Hinge Pin

from the Middle Hinge Bracket. Remove washer under-

neath the middle hinge and set aside.

NOTE: At this point the door will be loose. Slightly lift the

door and remove it.

Loosen and remove the two bolts and use the Phillips head

screwdriver to remove the Middle Hinge Bracket from the

refrigerator housing. Set parts aside.

Remove the washer from the Bottom Hinge Pin. Using a

¼" socket wrench, loosen and remove the Hinge Pin from

the Bottom Hinge. Reattach the Hinge Pin to the opposite

side of the hinge.

NOTE: This is easier to do while the hinge is still attached.

REFRIGERATOR INSTALLATION

Using a 3/8'' socket wrench with a 2-Inch extension and

screwdriver, loosen the two bolts and one screw, and

remove the Bottom Hinge from right side of the housing.

Remove the Decorative Caps on the bottom of the refrig-

erator housing. You will need these holes for the Bottom

Hinge.

Move the Bottom Hinge to the left side of the housing,

keeping the same orientation, and reattach with the two

bolts and one screw. The ﬂat screw must be placed on

the exterior side of the hinge. Move the Decorative Bolt

to the hole on the lower right side of the housing.

Turn the refrigerator door upside down on a

nonscratching surface. Loosen the two screws to

remove the Bottom Hinge Pin Insert Bracket with the

Hinge Pin Insert.

NOTE: The leveler is only present on some models.

Leveler

WARNING: If you reinstall or replace doors, move the

leveler to the opposite site.