LG LHTNS2403 Serie Manuel Du Propriétaire page 18

WATER DISPENSER (On some models)
To dispense cold water, push on the dispenser switch with a
glass.
Dispenser
Switch
Some dripping may occur after dispensing. Hold your cup
beneath the dispenser for a few seconds after dispensing to
catch all of the drops.
WARNING: Do not put your fingers up the ice chute
opening. Doing so can result in severe injury.
CAUTION: Do not dispense ice into fine china or
crystal glasses. China or crystal can break.
AUTOMATIC ICEMAKER (on some models)
The icemaker will produce approximately 100-130 cubes in
a 24-hour period, depending on freezer compartment
temperature, room temperature, number of door openings
and other operating conditions.
It takes about 12 to 24 hours for a newly installed refrig-
erator to begin making ice. Wait 72 hours for full ice
production to occur.
Ice making stops whe n the bin fills to the level of the feeler
arm.
To turn off the automatic icemaker, set the icemaker
switch to OFF (O). To turn on the automatic icemaker,set
the switch to ON (I).
The water pressure must be between 20 and 120 psi on
models without a water filter and between 40 and 120 psi
on models with a water filter
amount and size of ice cubes.
CAUTION:
Throw away the first few batches of ice (about 24 cubes).
This is also necessary if the refrigerator has not been used
for a long time.
Never store beverage cans or other items in the ice bin for
the purpose of rapid cooling. Doing so may damage the
icemaker or the containers may burst.
Never use thin crystal glass or crockery to collect ice. Such
containers may chip or break resulting in glass fragments
in the ice.
Personal Injury Hazard
DO NOT place fingers or hands on the automatic ice
making mechanism while the refrigerator is plugged in.
USING YOUR REFRIGERATOR
to produce the normal
WARNING
Icemaker
WHEN YOU SHOULD SET THE ICEMAKER
POWER SWITCH TO OFF (O)
When the water supply will be shut off for several hours.
When the ice bin is removed for more than one or two
minutes.
When the refrigerator will not be used for several days.
NOTE: The ice bin should be emptied when the icemaker
ON/OFF switch is turned to the OFF position.
NORMAL SOUNDS YOU MAY HEAR
The icemaker water valve will buzz as the icemaker fills with
water. If the power switch is in the ON (I) position, it will buzz
even if it has not yet been hooked up to water. To stop the
buzzing, move the power switch to OFF (O).
NOTE: Keeping the power switch in the ON (I) position
before the water line is connected can damage the
icemaker.
You will hear the sound of cubes dropping into the bin and
water running in the pipes as the icemaker refills.
PREPARING FOR VACATION
Set the icemaker power switch to OFF (O) and shut offthe water
supply to the refrigerator.
NOTE: The ice bin should be emptied anytime the icemaker
ON/OFF switch is turned to the OFF (O) position.
If the ambient temperature will drop below freezing, have a
qualified technician drain the water supply system to prevent
serious property damage due to flooding caused by ruptured
water lines or connections.
17
Ice detecting
sensor
Power Switch