OPERATION - General information
The below description goes with the image on page 2.
1. Adjustable speed controller
2. Pulse button (I)
3. Pulse button with turbofuction (II)
4. Motor unit
5. Whisk attachment
6. Mixing beaker
7. Black attachment
OPERATION - Before first use
1. Take the appliance out of the packaging.
2. Clean the appliance (see 'Cleaning and maintenance').
OPERATION - Blender attachment
The blender attachment is perfectly suited for preparing purees, sauces, dips, soups, mayonnaise and
baby food as well as for mixing drinks and milkshakes. The appliance is equipped with an adjustable speed
controller and two pulse buttons. Pulse button (I) acts like an on- and off switch en pulse button (II) acts like
a turbo button.
1. Insert the whisk (5) into the black attachment (7) until it's locked in.
2. Fit the motor unit (4) onto the blender attachment (8), and lock the parts by turning one part to the left. Keep
turning until it clicks.
3. Place the ingredients in a bowl or the provided mixing beaker (6). Add a small amount of liquid, such as
milk, fruit juice or water, to make the ingredients easier to mix.
4. Potatoes and vegetables can be pureed directly in the saucepan. First take the saucepan away from the
heat source and place it on a flat and stable foundation.
5. Insert the plug into the wall socket.
6. Keep the hand blender upright in the bowl, mixing beaker or saucepan.
7. Turn on the appliance by pressing one of two pulse-buttons. Use the adjustable speed controller (1)
in combination with pulse button (I) (2). First press pulse button (I), then use the adjustable speed
controller by turning it to the left or right to determine the speed. For mixing on the highest speed, you
can use the pulse button (II) with turbofunction (3).
8. Keep hold of the bowl/saucepan/mixing beaker during use so that it cannot slide off the work surface.
Be careful, the saucepan can still be hot.
9. The appliance shuts off automatically when the pulse button is released.
10. Remove the plug from the wall socket when finished.
WARNING:
•
Never turn on the appliance if it isn't in the bowl/saucepan/mixing beaker. Otherwise, the sharp knife
may cause serious injury.
•
The appliance may not be used for more than one minute at a time. The appliance needs to cool down
to room temperature.
ASSEMBLING AND SEPARATING THE BLADES
1. Place the longest (bottom) blade on a flat surface.
2. Assemble the blades by pushing the upper blade onto the bottom blade. Then turn the upper blade
counter-clockwise to join the blades together. Ensure both blades are firmly attached.
3. Separate the steel blades by holding the lower blade firmly. Then turn the upper blade clockswise before
pulling them apart.
ATTENTION:
•
The blades are very sharp, handle with caution!
•
Ensure all four blades are covered by the plastic protection before assembling and separating them.
8. Blender attachment
9. Cord en plug
10. Lid
11. Stainless steel blade
12. Mixing-cup
13. Mounting pin
17
17
EN
EN