Publicité
STEP 1 – PASO 1 – ÉTAPE 1 – FASE 1 – STEP 1 – STAP 1
Lock the Front Stabilizer (pt.9) to the Main Frame (pt.10) with two sets of Ø10 Curved Gasket (pt.6), M10 Domed
Nut (pt.7) and M10*90 Carriage Bolt (pt.3).
Lock the Rear Stabilizer (pt.4) to the Main Frame (pt.10) with two sets of Ø10 Curved Gasket (pt.6), M10 Domed
Nut (pt.7) and M10*90 Carriage Bolt (pt.3).
STEP 2 – PASO 2 – ÉTAPE 2 – FASE 2 – STEP 2 – STAP 2
Put the Vertical Seat Post (pt.16) into the seat post tube on the Main Frame. You will have to slacken the Knob
(pt.11) and pull the knob back. Then select the desired height. Release the knob and retighten the knob. The
Seat Post (pt.17) fixed on the Vertical Seat Post (pt.16) with the Knob (pt.12) and the Flat Washer (pt.13).
Finally,the Seat (pt.18) fixed on the Seat post (pt.17) as shown,and tighten the nuts under the seat.
FYTTER |WWW.FYTTER.COM
PAG- 13
Publicité
