Adjusting The Listening Position; Using Rear Speakers As Subwoofer - Rear Bass Enhancer - Sony CDX-GT710HD Mode D'emploi

Adjusting the listening
position
You can fine-tune the listening position
setting.
1
During reception/playback, press
, rotate the control dial until
"SOUND" appears, then press it.
2
Rotate the control dial until
"POSITION" appears, then press it.
3
Rotate the control dial until "ADJ
POSITION" appears, then press it.
4
Rotate the control dial to adjust the
listening position, then press it.
Adjustable range: "+3" – "CENTER" –
"–3."
5
Press
previous display.
DM+ Advanced
DM+ Advanced improves digitally
compressed sound by restoring high
frequencies lost in the compression process.
During playback, press , rotate
1
the control dial until "SOUND"
appears, then press it.
2
Rotate the control dial until "DM+"
appears, then press it.
3
Rotate the control dial to select "ON,"
then press it.
4
Press
previous display.
Tip
The DM+ setting can be memorized for each
source other than the tuner.
22
(BACK) to return to the
(BACK) to return to the
Using rear speakers as
subwoofer — Rear Bass
Enhancer
Rear Bass Enhancer enhances the bass
sound by applying a low pass filter setting
(page 24) to the rear speakers. This function
allows the rear speakers to work as a
subwoofer if one is not connected.
1
During reception/playback, press
, rotate the control dial until
"SOUND" appears, then press it.
2
Rotate the control dial until "RB ENH"
appears, then press it.
3
Rotate the control dial until "RBE
MODE" appears, then press it.
4
Rotate the control dial to select from
"1," "2" or "3," then press it.
5
Press (BACK) to return to the
previous display.
Using a subwoofer without a
power amplifier
— Subwoofer Direct
Connection
You can use the subwoofer without a power
amplifier when it is connected to the rear
speaker cord.
Note
Be sure to connect a 4 - 8 ohm subwoofer to
either of the rear speaker cords. Do not connect a
speaker to the other rear speaker cord.
1
During reception/playback, press
, rotate the control dial until
"SOUND" appears, then press it.
2
Rotate the control dial until "SW
DIREC" appears, then press it.
3
Rotate the control dial until "SW
MODE" appears, then press it.