Publicité
Les langues disponibles
Les langues disponibles
holder, slide the flat head of the chuck key handle into the
chuck key holder
10
as shown. Snap the handle's shaft into
the retention clip
11
on the holder.
To remove the chuck key from its holder, pull the chuck key
handle out of the holder and slip the flat head out of the hole.
nOTE: To avoid losing the chuck key, do not store it in any
other orientation.
Fig. F
Installing and Releasing a Bit (Fig. A)
Open the keyed chuck jaws by turning the collar by hand
then insert the shank of the bit about 3/4" (19 mm) into
chuck. Tighten the chuck collar by hand. Place chuck
key (
, Fig. A) in each of the three holes, and tighten
6
in clockwise direction. It's important to tighten chuck
with all three holes. To release the bit, turn the chuck
counterclockwise in just one hole, then loosen the chuck
by hand.
nOTE: When using hex shank or three-sided shank bits, be
sure to align the flat sides of the bit with the chuck jaws to
ensure the bit is properly engaged by the jaws.
Worklight (Fig. A)
CAUTION: Do not stare into worklight. Serious eye
injury could result.
The worklight
is activated when the trigger is depressed,
7
and will remain on for a short time after the trigger is
released. If the trigger remains depressed, the worklight will
remain on.
nOTE: The worklight is for lighting the immediate work
surface and is not intended to be used as a flashlight.
D
WALT Bluetooth® Tool Tag Ready
e
(Fig. A, G)
Optional Accessory
WARNING: Read instruction manual for the D
Bluetooth® Tool Tag.
WARNING: Remove battery from tool before installing
the D
WALT Bluetooth® Tool Tag.
e
10
WARNING: When installing or replacing the D
Bluetooth® Tool Tag, use only the screws provided. Be
sure to securely tighten the screws.
Your tool comes with mounting holes and fasteners
installing a D
WALT Bluetooth® Tool Tag (DCE041). You will
e
need a flat-blade screwdriver to install the tag. Screw torque
should be between 0.8 and 1.2 Nm (7.1 to 10.6 in-lbs). The
D
WALT Tool Tag is designed for tracking and locating
e
professional power tools, equipment, and machines using
6
the D
WALT Tool Connect™ app. For proper installation of
e
the D
WALT Tool Tag, refer to the D
e
To learn more, visit:
www.D
WALT.com/en-us/jobsite-solutions/tool-connect
e
Fig. G
6
11
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. H)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
and firmly pull the battery pack out of the tool
2
handle. Insert it into the charger as described in the charger
section of this manual.
English
WALT
e
WALT
e
12
WALT Tool Tag manual.
e
12
into the tool handle, align the
1
for
9
Publicité
